Drilling and Pattern Recognition

Drilling and Pattern Recognition

There are several methods of drilling in Router-CIM.  Some of them depend on the type of machine you have and how it is configured.  There are cycles for drilling with a standard spindle, drilling with a dedicated boring block, canned cycles for drilling and even drilling cycles that allow the machine to move rapidly between drill holes, allowing a lower cycle time.

The actual Router-CIM cut cycles covered in this documentation are:

Drill Motions

Fast Drill

Drill Interpolation

Spot Bore (Canned Cycle)

Peck Bore (Canned Cycle)

Pattern Recognition

Hole Interp-1

Hole Interp-2