Router Sample 3

Router Sample 3

Router Sample 3 will demonstrate the use of Router-CIM Automation software.  The automation software will allow for the cutting, nesting (if necessary), and sequencing of parts from within Router-CIM for any number of parts without the need for you, the user, to interact with each part.

To accomplish this, Router-CIM uses a drawing that you create with cut knowledges in it, a DOIT file that has the layer to knowledge association for each of those cut knowledges and finally a selection of parts, each of which has geometry separated onto layers that match the layers found in the DOIT file.

This will be a brief demonstration of the automation software, but will give you an overview of the steps necessary to run a job once the automation software is properly set up.