Router-CIM Automation

RCIM_2017_Header


RCIM_2017_Header


Previous topic Next topic  

RCIM_2017_Header


Previous topic Next topic  

About NCVARs

There are occasions when the "standard" installation of Router-CIM may not be applicable to your machine tool.  Usually this can be fixed using the NCVARs, which are specific variables that Router-CIM uses to control the program.

 

You should only change the NCVARs when instructed to either by this manual or after consulting CIM-Tech.  An improper setting could cause a failure in Router-CIM that may be hard to track down.