Router-CIM Automation Suite

rcim_2024_header


rcim_2024_header


Previous topic Next topic  

rcim_2024_header


Previous topic Next topic  

GEOMETRIC VARIABLES

 

*brng*

Largest gap in data for BLEND if NCJOIN is "T" to close

 

*cstrang*

Start angle (expressed in degrees) for circular shapes. 0 starts at 3 o'clock.

 

*cutfil*

Offset fillet radius for rounded corner filleting in CUT.

 

*endmrgn*

End margin on slicer for 3D surface machining

 

*leadfed*

This is the percentage of the programmed feedrate that the lead in will be performed at.

 

*leadratio*

A value used in an equation to determine the angle of entry for Heli-lead cycles.

 

*ncjoin*

Use polyline join with *brng* tolerances to close gaps in geometry commonly caused by DXF or IGES transfers.

 

*offvect*

NOT USER CONFIGURABLE

 

*pat_fuzz*

Value for pattern recognition tolerance amount

 

*r4x_corner_incr*

This variable controls the Router-CIM 4th axis interpolation cycle. This value controls how long the segments should be when interpolating around an inside corner.

 

*r4x_corner_offset*

This variable controls the Router-CIM 4th axis interpolation cycle. This is the distance from the inside corner the inside corner cuts will start.

 

*reduceopt*

To reduce surface machining tool path to arcs the response is "r" and "s" for no reduction to arcs.

 

*reducezero*

Data reduction tolerance of slicer for producing arcs in 3 axis machining.