Router-CIM Automation Suite

Parametric_Macro_Builder_Header


Parametric_Macro_Builder_Header


Previous topic Next topic  

Parametric_Macro_Builder_Header


Previous topic Next topic  

CutOut

There are five different types of CutOut Operations available:

Mac_CutOut_Types

Circle
Rectangle
Ellipse
Insert - uses a defined named block in the current drawing or a named drawing file
Profile - used the last defined (evaluated) Profile Operation

The checked type is the definition for the selected CutOut Operation.

Circle CutOut Parameters

Mac_CutOut_Circle_Parameters

X Center - X location of Circle
Y Center - Y location of Circle
Z Start - Z location of Circle
Depth - depth of Circle
Radius - radius of Circle

Rectangle CutOut Parameters

Mac_CutOut_Rectangle_Parameters

X Start - X start location of Rectangle
Y Start - Y start location of Rectangle
X Length - length of Rectangle in X
Y Width - width of Rectangle in Y
Depth - depth of Rectangle
Radius - radius of corner fillets

Ellipse CutOut Parameters

Mac_CutOut_Ellipse_Parameters

X Center - X center of Ellipse
Y Center - Y center of Ellipse
Z Start - Z location of Ellipse
X Length - length of major axis
Y Width - length of minor axis
Depth - depth of Ellipse
Rotation - rotation angle in degrees

Insert CutOut Parameters

Mac_CutOut_Insert_Parameters

X Start - X location of Block insert
Y Start - Y location of Block insert
Z Start - Z location of Block insert
Scale - scale of Block insert
Rotation - rotation angle in degrees
Blk. Name - name of Block
[Browse Blocks...] - displays a list of block names in the current drawing for selection
[Browse Drawings...] - displays a list of drawing files for selection

Profile CutOut Parameters

Mac_CutOut_Profile_Parameters

No Parameters - a display of the last evaluated Profile in the Macro sequence prior to this CutOut Operation.

Pocketing Parameters

Mac_CutOut_Pocketing_Parameters

Any of the CutOut types can be pocketed. Pocketing is the process of developing tool motions that will remove all the material inside of the CutOut.

The method of pocketing is in a Spiral Offset path.

Offset - the offset distance of the tool path next to the edge of the CutOut
Step Over - the distance between all other tool paths in the pocket.

Array Parameters

The array parameters are exactly the same as those detailed in the Drill Operation. Reference the Drill Operation.

Validation Process

Each combination described above is validated for the correct number and types of parameters defined. The parameters must meet one of the above combinations to be accepted.

Sides, Corners, and UCS Override

Reference the Sides, Corners and UCS for details.

Condition and Record Data

Reference the Editor Interface for details.